HEATER CRAFT YAMAHA RHINO 450 INSTALLATION INSTRUCTIONS & OWNER’S MANUAL
KIT CONTENTS: QTY. 1 HEATER UNIT QTY. 2 MOUNTING BRACKETS QTY. 1 OVAL VENT QTY. 4.00” OF TRIM RUBBER QTY. 8’ OF 2.00” VENT HOSE QTY. 2 VENTS (2
MOUNT HEATER UNIT: Install brackets as shown using provided #8-32 screws provided. Remove the battery box cover and loosen the four (4) retai
PLUMBING: Remove lower radiator hose and drain into catch pan. Install and clamp the provided coupling in the open end of the removed radiator
PLUMBING: cont. Install the 4.00” piece of Trim Rubber on the vertical edge of the radiator to protect the installed heater hose. VENTS
VENTS AND HOSE ROUTING Cont. Place the oval vent’s plenum under the dash and sandwich the dash between the grill and plenum. Use the #10 x 3/4” screw
WIRING/ELECTRICAL: Locate Black ground wire from heater motor and cut/route to the Negative post on the battery using the provided Ring Terminal.
Comments to this Manuals